Creates 4 story town homes with an alley between

To use the subdivision - townhomes flow:

Click the Lightning Bolt

Select “subdivision - townhomes”

Click to start the shape.

Click again to add a corner.

Drag and click to define the length.

<aside> 👉 Subdivision - townhomes uses Rectangle based geometries.

</aside>

Default Settings:

To edit the settings after drawing it:

Click into “generated features” in the properties palette:

Subdivide to Lots settings

• Solve for Frontage or Area
  • Frontage: solves for a target length of the front of the parcel
  • Area: Solves for a target area of the parcel (not the envelope)
• Toggle splitting on the spine (divide down the center)
• Flip the direction the algorithm solves from
• Solve spine automatically or manually edit
  • Automatic divides the shape evenly down the horizontal center
  • Manual allows you to edit the start and end point of the spine, and add corners.
• Targets
  • Set inner and end area targets: The algorithm will target these areas with a margin of error, and lots may be slightly larger or smaller
  • Set inner and end frontages: The algorithm wall target these areas with a margin of error, and lots may be slightly larger or smaller
• Absolute Minimums
  • Prevent the algorithm from creating lots smaller than a size you select
  • Set minimum areas and frontages
• Envelopes
  • Toggle generation of building envelopes
  • Adjust setbacks for front, rear, and sides

Back to All of the Included Flow Templates